Manually configure IPv6 TCP/IP parameters from the control panel

HP Laserjet P3010 hp logo Manually configure IPv6 TCP/IP parameters from the control panel

Connectivity

 English

Manually configure IPv6 TCP/IP parameters from the control panel

Use the control-panel menus to manually set an IPv6 address.

1.
Press the Menu button HP Laserjet P3010 menu Manually configure IPv6 TCP/IP parameters from the control panel.
2.
Open each of the following menus. Press the down arrow HP Laserjet P3010 arrow down Manually configure IPv6 TCP/IP parameters from the control panel to highlight it and then press the OK button to select it.
a.
CONFIGURE DEVICE
b.
I/O
c.
EMBEDDED JETDIRECT MENU
d.
TCP/IP
e.
IPV6 SETTINGS
f.
ADDRESS
g.
MANUAL SETTINGS
h.
ENABLE
i.
ON
j.
ADDRESS
3.
Use the numeric keypad, or press the up arrow HP Laserjet P3010 arrow up Manually configure IPv6 TCP/IP parameters from the control panel or the down arrow HP Laserjet P3010 arrow down Manually configure IPv6 TCP/IP parameters from the control panel to enter the address. Press the OK button.
HP Laserjet P3010 note Manually configure IPv6 TCP/IP parameters from the control panel NOTE:

If you are using the arrow buttons to enter the address, you must press the OK button after entering each character.

4.
Press the up arrow HP Laserjet P3010 arrow up Manually configure IPv6 TCP/IP parameters from the control panel or the down arrow HP Laserjet P3010 arrow down Manually configure IPv6 TCP/IP parameters from the control panel to select the stop character HP Laserjet P3010 stop Manually configure IPv6 TCP/IP parameters from the control panel. Press the OK button.
5.
Press the Menu button HP Laserjet P3010 menu Manually configure IPv6 TCP/IP parameters from the control panel to return to the Ready state.
© Hewlett-Packard Development Company, L.P
HP Laserjet P3010 Manually configure IPv6 TCP/IP parameters from the control panel