Manually configure IPv4 TCP/IP parameters from the control panel

HP Laserjet P3010 hp logo Manually configure IPv4 TCP/IP parameters from the control panel

Connectivity

English

Manually configure IPv4 TCP/IP parameters from the control panel

Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.

1.
Press the Menu button HP Laserjet P3010 menu Manually configure IPv4 TCP/IP parameters from the control panel.
2.
Open each of the following menus. Press the down arrow HP Laserjet P3010 arrow down Manually configure IPv4 TCP/IP parameters from the control panel to highlight it and then press the OK button to select it.
a.
CONFIGURE DEVICE
b.
I/O
c.
EMBEDDED JETDIRECT MENU
d.
TCP/IP
e.
IPV4 SETTINGS
f.
CONFIG METHOD
g.
MANUAL
h.
MANUAL SETTINGS
i.
IP ADDRESS, SUBNET MASK, or DEFAULT GATEWAY
3.
Use the numeric keypad, or press the up arrow HP Laserjet P3010 arrow up Manually configure IPv4 TCP/IP parameters from the control panel or the down arrow HP Laserjet P3010 arrow down Manually configure IPv4 TCP/IP parameters from the control panel to increase or decrease the number for the first byte of the IP address, subnet mask, or default gateway.
4.
Press the OK button to move to the next set of numbers, or press the back arrow HP Laserjet P3010 arrow return Manually configure IPv4 TCP/IP parameters from the control panel to move to the previous set of numbers.
5.
Repeat steps 3 and 4 until the IP address, subnet mask, or default gateway is complete, and then press the OK button to save the setting.
6.
Press the Menu button HP Laserjet P3010 menu Manually configure IPv4 TCP/IP parameters from the control panel to return to the Ready state.

© Hewlett-Packard Development Company, L.P
HP Laserjet P3010 Manually configure IPv4 TCP/IP parameters from the control panel