Link speed and duplex settings

HP Laserjet P3010 hp logo Link speed and duplex settings

Connectivity

English

Link speed and duplex settings

The link speed and communication mode of the print server must match the network. For most situations, leave the product in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the product from communicating with other network devices. If you need to make changes, use the product control panel.

HP Laserjet P3010 note Link speed and duplex settings NOTE:

Making changes to these settings causes the product to turn off and then on. Make changes only when the product is idle.

1.
Press the Menu button HP Laserjet P3010 menu Link speed and duplex settings.
2.
Open each of the following menus. Press the down arrow HP Laserjet P3010 arrow down Link speed and duplex settings to highlight it and then press the OK button to select it.
a.
CONFIGURE DEVICE
b.
I/O
c.
EMBEDDED JETDIRECT MENU
d.
LINK SPEED
3.
Press the down arrow HP Laserjet P3010 arrow down Link speed and duplex settings to highlight one of the following options.


Setting
Description
AUTO
The print server automatically configures itself for the highest link speed and communication mode allowed on the network.
10T HALF
10 megabytes per second (Mbps), half-duplex operation
10T FULL
10 Mbps, full-duplex operation
100TX HALF
100 Mbps, half-duplex operation
100TX FULL
100 Mbps, full-duplex operation
100TX AUTO
Limits auto-negotiation to a maximum link speed of 100 Mbps
1000TX FULL
1000 Mbps, full-duplex operation
4.
Press the OK button. The product turns off and then on.

© Hewlett-Packard Development Company, L.P
HP Laserjet P3010 Link speed and duplex settings